Interlogix TruVision 360° Configuration Manual - Manual (Page 15)

TruVision 360° Camera Configuration Manual 13
Configuring network settings
Accessing the camera through a network requires that you define certain network
settings. Use the “Network” folder to define the network settings. See Figure 6 below for
further information.
Figure 6: Network window (TCP/IP window shown)
Parameters Description
1. TCP/IP NIC Type: Specifies the NIC type. Default is Auto. Other options
include: 10M Half-dup, 10M Full-dup, 100M Half-dup and 100M Full-
dup.
DHCP: Enable to automatically obtain an IP address and other network
settings from that server.
IPv4 Address: Specifies the IPv4 address of the camera.
IPv4 Subnet Mask: Specifies the IPv4 subnet mask.
IPv4 Default Gateway: Specifies the IPv4 gateway IP address.
IPv6 Mode: Specifies the IPv6 mode, including Manual ( Static),
Automatic (DHCP) and Neighbor Discovery (Router Advertisement).
IPv6 Address: Specifies the IPv6 address of the camera.
IPv6 Subnet Prefix Length: Specifies the IPv6 prefix length.
IPv6 Default Gateway: Specifies the IPv6 gateway IP address.
MTU: Specifies the valid value range of MTU. Default is 1500.
Multicast Address: Specifies a D-class IP address between 224.0.0.0
to 239.255.255.255. Only specify this option if you are using the
multicast function. Some routers prohibit the use of multicast function
in case of a network storm.
DNS server: Specifies the DNS server for your network.