Interlogix TruVision 360° Configuration Manual - Manual (Page 19)

TruVision 360° Camera Configuration Manual 17
To set up the Email parameters:
1. Click Configuration > Network > Email .
2. Configure the following settings:
Sender: The name of the email sender.
Sender’s Address: The email address of the sender.
SMTP Server: The SMTP Server IP address or host name.
SMTP Port: The SMTP port. The default is 25.
Enable SSL: Check the checkbox to enable SSL if it is required by the SMTP
server.
Attached Image: Check the checkbox of Attached Image if you want to send
emails with attached alarm images.
Interval: This is the time between two actions of sending attached images.
Authentication: If your email server requires authentication, check this checkbox to
use authentication to log in to this server. Enter the login user name and password.
Receiver: The name of the user to be notified.
Receiver’s Address: The email address of user to be notified.
3. Click Save to save changes.
To set up the NAT parameters:
1. Click Configuration > Network > NAT .
2. Check the checkbox to enable the NAT function.
3. Select Port Mapping Mode to be Auto or Manual. When you choose Manual mode,
you can set the external port as you want.
4. Click Save to save changes.
Defining recording parameters
You can adjust the video and audio recording parameters to obtain the picture quality
and file size best suited to your needs. See Figure 7 on page 18 for the video and audio
recording options that you can configure for the camera.