Chaparral K5312/K7313 - Manual (Page 11)

1-1
1
Introduction
This User’s Guide explains how to install and use the Chaparral G- and K-Series
External RAID Controllers, which are designed to be installed in a RAID enclosure
and used with a host system to provide a powerful disk subsystem.
The G5312 and K5312 RAID controllers are fault-tolerant SCSI-to-SCSI RAID
controllers that bridge the SCSI interface between the host system and the SCSI hard
drive peripherals. They support low voltage differential (LVD) Ultra2 or single-ended
Ultra SCSI buses. The G5312 and K5312 have one Ultra2 SCSI host channel and two
Ultra2 SCSI disk channels. Each disk channel is a separate SCSI bus.
The G7313 and K7313 offer all of the features of the G5312 and K5312 except that
they support Fibre Channel (FC) connectivity, single loop. They each have one FC
host and three Ultra2 SCSI disk channels.
Administrative software is embedded in firmware; thus, the G- and K-Series requires
no specific software drivers for the host operating system.
About This Guide
This User’s Guide describes how to install and configure your Chaparral RAID
controller. It assumes that you are familiar with the basic functions of your computer
system. It also assumes that you are familiar with SCSI and Fibre Channel
configurations and basic network administration terminology.