Chaparral K5312/K7313 - Manual (Page 97)

Configuring the Controller
7-17
Include All Hosts—Permits all servers (hosts) on the network to access the
selected array. This is the default zone type. This results in all servers (hosts)
being able to access all arrays. If you have already created an include or
exclude list, you can use this option to override the list. Your existing list is
retained and you can display, add, or remove servers from the list.
Include Listed Hosts—Lets you enter or select the WWNs of the specific
servers (hosts) you want to be able to access the selected array.
Exclude All Hosts—Permits no servers (hosts) on the network to access the
selected array. If you have already created an include or exclude list, you can
use this option to override the list. Your existing list is retained and you can
display, add, or remove servers from the list.
Exclude Listed Hosts—Lets you enter or select the WWNs or names
(aliases) of the specific servers (hosts) you do not want to be able to access
the selected array.
Whether you use an include or exclude list depends on your needs. You may
want to determine which list would be shorter and create the shorter list.
If you have changed the LUN zoning, the system confirms that you want to
make the change.
5
Select Yes and press Enter to make the changes.
The system confirms that the changes are made.
6
Press Esc to return to the LUN Zoning screen.
Changing the Sample Rate
You can set how often the controller samples data when updating status screens (disk
and array). The default is one second.
To change the sample rate:
1
From the System Menu, select Configuration Menu and press Enter.
The Configuration Menu screen displays.
2
Select New Sample Rate and press Enter.
The New Sample Rate screen displays.
3
Enter the sample rate and press Enter.