Chaparral K5312/K7313 - Manual (Page 103)

Configuring the Controller
7-23
To change Utility priority:
1
From the System Menu, select Configuration Menu and press Enter.
The Configuration Menu screen displays.
2
Select Utility Priority and press Enter.
The Utility Priority screen displays. The current setting is marked with an *
next to it.
3
Select the option you want and press Enter.
Rescanning All Channels
You can tell the controller to scan all disk channels for new or removed disk drives.
You can use this option when you install or remove drives. The Rescan temporarily
pauses all I/O processes and then resumes normal operation.
If you are using an enclosure with a SEP, the controller will perform a rescan
automatically for you. With a SEP, the controller will detect removed drives almost
immediately; however, installed drives will be detected after a three-minute delay.
This delay is to allow the new drives to spin-up.