Keri Systems HPP-100 - Manual (Page 3)

HPP-100 Hand-Held Programmer
Revision 3.3 iv
Contents
THE HPP-100 HAND-HELD PROGRAMMER 1
Programming Command Groups 2
System Preparation 3
Applying Power to the Master Control Unit 3
The Master Control Reader’s LED 4
The Personal Identification Number (PIN) 4
Using the PIN to Enter Programming Mode 4
Setting a New PIN 5
Configuring the Serial Port 6
Command Descriptions 8
Standard Commands 9
Timing Functions 9
Set the Date [G] 9
Set the Time [G] 9
Set the Unlock Time [N] 10
Set the Held-Open Time [N] 10
Set the Close of Business Time [N] 10
Card Management Functions 11
Enroll a Card in a Slot and a Time Zone [G] 11
Enroll Cards in Batch Mode [G] 12
Void a Card [G] 13
Voiding Consecutive Cards [G] 14
Change a Card’s Time Zone [N] 14
Change the Time Zone for Consecutive Cards [N] 15
Printing Functions 15
Verify a Card [G] 15
Print Transactions [G] 16
Print Enrolled Cards [G] 16
Print Status Information [G] 17
Print the Last nnnn Transactions [G] 18
Print Cards from a Time Zone [G] 19
Group 0/Memory Module Commands 20
Card, Time Zone, and Anti-Passback Functions 20
Exit Command Mode [n/a] 20
Define a Time Zone [G] 20
Set Anti-Passback [N] 21
Set Auto-Unlock Time Zones [N] 22
Memory Module Functions 22
Set the Data File Identifier [n/a] 23
Transfer Cards to the Memory Module [N] 23
Transfer Events to the Memory Module [N] 24
Erase the Memory Module [n/a] 24
Erase Events in the Memory Module [n/a] 24
Transfer Cards from the Memory Module [G] 25
Contents (continued)