Keri Systems HPP-100 - Manual (Page 41)

HPP-100 Hand-Held Programmer
Revision 3.3 35
NEW PIN _ _ _ _
Press . . . [1] [1] [5] [6]
[ENROLL] [CLEAR]
NEW PIN * * * *
Press . . . [ENRL]
CHANGE PIN
NEW PIN _ _ _ _
Press . . . [1] [1] [5] [6]
[SEND] [CLEAR]
NEW PIN * * * *
Press . . . [SEND]
The Master Control Unit will now respond to the new PIN.
Clear Reader Memory [N]
Clearing Reader Memory completely erases all card/slot and event information and
restores the Master Control Unit to all of its factory default values. This command should
be used if the need arises to completely reprogram the system’s access control data.
Example . . . to clear reader memory:
Press . . . [0] [999] [SEND] [999] [SEND]
SYSTEM RESET
[SEND] [CLEAR]
If the serial printer is connected to the Master Control Unit, the Print Status Information
command will be executed immediately following the Clear Reader Memory command.
The Print Status Information command was described above in the Printing Functions
section.