Keri Systems HPP-100 - Manual (Page 45)

HPP-100 Hand-Held Programmer
Revision 3.3 39
HPP-100 Hand-Held Programmer Quick Start Guide
The following table is a quick reference guide to all commands that are available for the HPP-100 Hand-Held Programmer Guide. The following
information applies to the programmer and all programming commands.
•
While NOT in programming mode:
• pressing [LVL] toggles Monitor Mode on and off
• pressing [SND] toggles the LCD display through system status screens (time, date, software version, responding readers).
•
Commands must be entered while in Programming Mode.
• To enter Programming Mode, the correct, 4-digit PIN must be entered.
• Pressing the [SND] key completes commands.
• Press [CLR] at any time to cancel a command in progress.
•
Global Commands apply to all Control Units/Readers on the network. Non-Global Commands apply to either an individual Control
Unit/Reader or to all Control Unit/Readers on the Favorite Reader List (FRL)
• To select a specific Reader, press [LVL] followed by the Reader number (1-6). The Reader number will appear in the upper-right
field of the LCD display.
• To select all readers on the FRL, press ZIP (an * will appear in the upper-right field of the LCD display).
Standard Commands G / N Key-In Data Parameters
Set Date G 7 [mm dd yy] SEND month, day, year
Set Time G 8 [hh mm] SEND hour (00-23), minute
Set Unlock Time N 4 [ss] SEND seconds (01-99)
Set Held-Open Time N 5 [ss] SEND seconds (01-99)
Set COB Time N 6 [hh mm] SEND hour (00-23), minute
Enroll Card in Slot and Time Zone G ENRL [slot#] LVL [tz#] SEND (0000-6999), (0-5, 7)
Enroll Cards in Batch Mode G ENRL [slot#] ZIP [slot#] LVL [tz#] SEND (0000-6999), (0000-6999), (0-5, 7)
Void a Card G VOID [slot#] SEND (0000-6999)
Void Consecutive Cards G VOID [slot#] ZIP [slot#] SEND (0000-6999), (0000-6999)
Change Card Time Zone N 3 [slot#] LVL [tz#] SEND (0000-6990), (0-5, 7)
Change Consecutive Cards Time Zone N 3 [slot#] ZIP [slot#] LVL [tz#] SEND (0000-6999), (0000-6999), (0-5, 7)
Check Card G 1 [slot#] SEND (0000-6999)
Print Transactions G 0 0 SEND
Print Enrolled Cards G 2 SEND
Print Status Information G 2 0 SEND
Print the Last nnnn Transactions G 2 1 [nnnn] SEND (0000-9999)
Print Cards from a Time Zone G 2 LVL [tz#] SEND (0-5, 7)
HPP-100 Hand-Held Programmer Quick Reference Guide (continued)