Keri Systems HPP-100 - Manual (Page 35)

HPP-100 Hand-Held Programmer
Revision 3.3 29
Example . . . to enable daylight savings time:
Press . . . [LVL] [9] [7] [1]
DAYLIGHT SAVINGS
[0] = OFF [1] = ON
Favorite Reader List Functions
The Favorite Reader List is a list of readers on the access control network that are
programmed to be treated equally. Although all readers may be networked together,
programming commands that directed to readers on the favorite reader list affect all
readers on the list; programming commands directed to an independent reader (one not
on the favorite reader list) affect only that reader.
Display the Favorite Reader List [G]
The Display the Favorite Reader List command is used to display those readers that are
tied together on the favorite reader list versus those readers that are independent. All
readers will be listed by reader ID number; those on the favorite reader list will be
identified by a ‘+’ symbol.
Example . . . to view the favorite reader list:
Press . . . [LVL] [9] [1] (this shows there are 6 readers
on this network, addressed as 1
through 6)
1 2 3 4 5 6
+ + – – – –
(and that only readers 1 and 2
are on the favorite reader list)
Add a Reader to the Favorite Reader List [G]
Adding a Reader to the Favorite Reader List is used to add one reader to the favorite
reader list. To perform this command, you must know the address number of the reader
you wish to add.