Keri Systems HPP-100 - Manual (Page 39)

HPP-100 Hand-Held Programmer
Revision 3.3 33
Transfer Cards from the Master Reader to all Readers on the FRL [G]
Transferring Cards from the Master Reader to all Readers on the FRL is used to transfer
all time zone and system configuration attributes for a continuous set of cards from the
Master Control Unit to all other readers on the favorite reader list. To perform this
command, you must know the slot numbers of the cards you wish to add.
Example . . . to transfer cards 100 through 200 from the master reader to all readers on
the favorite reader list:
Press . . . [*] (selects all readers on the
favorite reader list)
[h] COMMAND [*]
ENTER OPTION
Press . . . [LVL] [9] [3]
TRANSFER CARDS
#: _ _ _ _ TO #: _ _ _ _
Press . . . [0] [1] [0] [0] [ZIP] [0] [2] [0] [0]
TRANSFER CARDS
#: 0 1 0 0 TO #: 0 2 0 0
At this point, you have a choice.
[LVL] [SND] [CLR]
#: 0 1 0 0 TO #: 0 2 0 0
You may . . .
Press . . . [SEND]
and all the current card/slot time zone and system configuration attributes will be
transferred as is.
Or you may assign a new time zone value for all the cards to be transferred. To assign a
new time zone value, you must know the new time zone value you wish to apply.
To assign a new time zone value of 3: