NORAC UC5-BC-AL Manual - Manual (Page 10)

6
5 Operation
5.1 Run Screen
Once the system is correctly configured, it is very simple to use. The majority of functional
settings and controls can be accessed on the main screen. An image of the boom, with the
height of each boom section is displayed.
To change between automatic and manual, press the button in the lower right corner of the
terminal. When the boom is blue, the UC5 system is in automatic. When the boom is black,
the UC5 system is in manual.
When the UC5 Height Control System is in automatic, arrows will appear on the screen above
or below the boom sections. These arrows indicate the UC5 system is making a correction to
part of the boom in the displayed direction. Often times the correction will be very small and
there may not be a noticeable change in boom position.
The height displayed on the boom is measured from the spray nozzles to the soil (soil mode) or
crop canopy (crop mode). If there are five height sensors on the sprayer, the height displayed
is the outer sensor height only. The main run screen is shown below for the Ag Leader®
InSight™, INTEGRA™, EDGE™ and VERSA™ Displays.
Figure 4: InSight™ Main Run-Screen
Boom Height Tab Auto / Manual
Button
Settings