NORAC UC5-BC-AL Manual - Manual (Page 22)

18
You will then be instructed to
hold the PROCEED button.
Continue holding while each
boom section is moved during the
“Sensor Detect Test”.
Then the terminal will display
“Cruising”. When it is done the
terminal will instruct you to
release the PROCEED button.
Do not move the booms at this
time.
The terminal will then instruct you
to exit the cab and pull the boom
tip down towards the ground, and
then release the boom.
Ensure you stay a minimum of 3
feet (1 m) away from any of the
sensors.
When finished, return to the cab.
Hold the PROCEED button and
continue holding it until you are
instructed to release it.
The system will now calibrate the
hydraulics. All boom sections will
move.
If you accidentally release the
button, press and hold the
PROCEED button to resume.