NORAC UC5-BC-AL Manual - Manual (Page 14)

10
5.3 Sprayer Switches
When a sprayer switch is pressed, an arrow will be displayed on the screen showing which
function is being activated. For example, if the left up switch is pressed then an arrow will be
shown above the left boom pointing up.
Tilt Switches:
While in automatic, if either left or right tilt switches are pressed, the corresponding boom
section will go into manual mode. This is useful when spraying near ditches or fences where
you would like to manually control one of the booms while leaving the other boom in
automatic mode. To return all boom sections to automatic, press the auto / manual button. If
the Double Tap Wings function is enabled, the tilt down switches can be used to resume
Automatic Mode.
Main Lift Switch:
While in automatic, if the main lift up or down switch is momentarily pressed, the target height
is incrementally adjusted up or down.
If Headland Assist (Section 9.1) is enabled with the trigger as the main lift switch, then the
main lift switch will be used to control Headland Assist instead of the target height. The main
lift up switch will activate Headland Assist. By pressing main lift down the system will return to
automatic mode.
Pressing and holding the main lift switch will always put the system into manual. If the Double
Tap Main function is enabled, the main lift down switch can be used to resume Automatic
Mode.
* Some sprayer types may not have all the functionality listed above.