NORAC UC5-BC-AL Manual - Manual (Page 27)

23
7.4 Manual Setup
The UC5 Height Control system will not operate in automatic mode until the system has been
configured. It is recommended that the automatic system setup be used, but if necessary a
manual system setup may be used. The manual system setup involves setting up each sensor,
valve output and remote switch input.
7.4.1 General Settings: Minimum Height Mode
Minimum height mode is normally used only for systems with five sensors (severe terrain kit).
Since the five sensor system has two wing sensors that average the height, it is possible to have
a boom tip close to the ground while still maintaining an acceptable average height. The
minimum height defines the lowest height in which a single sensor on the wings is allowed to
go.
The “relative” setting defines the number as the distance below the target height. The
“absolute” setting defines the number as the distance above the ground.
7.4.2 Sensor Setup
Before beginning, it is necessary to know the serial number and location
for each of the sensors. The sensor serial number is located on the
bottom of the sensor housing, beside the foam disc.
It is recommended that you record the sensor location and serial
number in Figure 9 , because this information may be required during
troubleshooting.
Figure 9: Sensor Serial Numbers and Positions