NORAC UC5-BC-AL Manual - Manual (Page 46)

42
9.10 Manual Valve Drive
Manual Valve Drive is normally defaulted off for most sprayer types. When enabled, this
feature will drive the corresponding valve when a switch input is detected. This feature only
needs to be enabled if the hardware installation requires it to be enabled. Please contact Norac
for assistance if you need to enable Manual Valve Drive.
9.11 Double Tap Main
When this option is enabled (checked), the system can be put into Automatic Mode by tapping
the main lift down switch twice. When this feature is enabled, the Setpoint Bump feature is
automatically disabled. Holding any of the up or down switches will still put the system into
Manual Mode. It is possible to have both the Double Tap Main and the Double Tap Wings
features enabled at the same time.
9.12 Double Tap Wings
When this option is enabled (checked), the system can be put into Automatic Mode by tapping
either the left down switch or the right down switch twice. Holding any of the up or down
switches will still put the system into Manual Mode.