Soniclean S2800 - Manual (Page 17)

6. Program Mode
The parameters can be altered by entering the program mode. There are 3 ways of entry to this mode.
6.1 Program Entry Points:
6.1.1 Alternative 1 – Program at Start Up
1. Press the “PROG” key then turn on the machine.
2. Hold the “PROG” down until the machine displays “CT 10”.
3. Release the “PROG” key.
6.1.2 Alternative 2 - Program during Operation:
1. When the machine will display “- - - -“
2. Hold down the “SHIFT” key and then press the “PROG” key and hold for 3 seconds.
6.2 Program Parameters:
To program the parameters, enter program mode as desired in 6.1, then:
1. The machine will display a variety of parameters that may reconfigure.
2. Press the arrow “UP” key to increase the parameter and the arrow “DOWN” key to decrease the
parameter.
3. To accept a value press “ENTER”. The display will scroll through the parameters.
4. Refer the tables below for parameters and values.
KEY TO PROGRAMMING DISPLAY
PARAMETER
DISPLAY UNIT MIN MAX FACTORY
SETTINGS
Clean time Ct mins 1 99 10
Ultrasonics power level PO 1 3 3
Clean number Cn 0 99 10
Detergent concentration SP percentage 0.0 5.0 0.5
Start up de-gassing time G1 mins 0 99 10
De-gassing time G2 mins 0 99 2
Test time tt sec 0 99 30
Irrigate default Id 0=Off 1=On 1
Irrigate rest periods
N.B. Irrigator on time is 5
secs
Ir 1 rest period
= 5 secs 5 period
(5x5 =
25 secs) 50 5
S-2800 Irrigator Operating Manual Page 13
© 2013-2014 Soniclean Pty Ltd Version 20 March 2014