Soniclean S2800 - Manual (Page 7)

1.3 Keypad Description
Name of key Function
▲ Increases values in program mode.
Enter Confirms the parameters in program mode. Initialises the machine in operate mode.
▼ Decreases values in program mode.
Shift Second function key. To activate the function noted in red below a button hold
down the second function key and press the required button. Functions accessed
this way are Drain, Refill, Reset and Prog.
Drain Drains the machine (takes approximately 2 mins). To initiate a manual drain, hold
down Shift key then press/hold Drain key for 3 seconds. This can be done at any
time.
Refill Drains the machine and refills with fresh water. To initiate a manual refill, hold
down Shift key, press/hold Refill key for 3 seconds. This can be done at any time
except during clean or de-gas cycles.
Reset Immediately aborts any current process that is operating in auto mode. Hold down
Shift and Reset keys together.
Irrigate On/Off Flushes inner lumen of instruments. Red light indicates irrigation feature is
operating.
Clean Commence ultrasonic cleaning and irrigation as programmed. Red light indicates
clean cycle is operating. Press Clean during the clean cycle to cancel the current
operation.
De-gas De-gassing removes air bubbles from the water prior to ultrasonic cleaning. Red
light indicates de-gas is operating. Press Degas during the degas cycle to cancel the
current operation.
Prog Places the machine in program mode to allow alterations to the programmed
settings. To enter program mode hold down Shift key and press/hold PROG key for
3 seconds when the machine is not running.
Test Operates the ultrasonic cleaning mode for 30 seconds for a foil test.
Clean Values Cleaning times and power levels may be changed without performing the complete
programming procedure.
Please refer to Operating Instruction (section 4) for detail guideline on using the keypad
S-2800 Irrigator Operating Manual Page 3
© Soniclean Pty Ltd Version 20 March 2014