Toa N-8000 Series - Manual (Page 283)

2-172
Chapter 2 FUNCTIONS AND OPERATION
OPERATION FROM AN OUTSIDE LINE
3.2.6. Confirming the reserved time signal schedule
The System Time Signal schedule reservation can be confirmed through operation from the outside line
telephone.
With an audible tone through the outside line telephone, its schedule reservation can be confirmed by operations
from the outside line telephone.
[Operation]
Step 1. Lift the handset and dial the N-8000CO's outside line number.
The N-8000CO unit automatically responds to the call and a dial confirmation tone is transmitted to
the caller.
Step 2. After hearing the dial confirmation tone, press the [ ][9][6][Outside Line Control Password* 1 (4 digits)]
keys in sequence.
The calling party can hear a tone* 2 indicating the reserved day and schedule, followed by a confirmation
tone (ding-dong).
But only a confirmation tone can be heard during time signal schedule suspension.
* 1 The outside line control password is required only when it has been set.
* 2 A beep is used to indicate the figure "1" and a long beep to indicate the figure "5." Remaining days
until the reserved day and all schedule numbers are indicated using beep tones. A short beep tone
sounds 3 times consecutively between the beep tones indicating the remaining days and schedule
number.
(Example)
In the case of remaining days until the reserved day is 1 and Schedule No. 3:
Beep-pause-a short beep-a short beep-a short beep-pause-beep-beep-beep
In the case of remaining days until the reserved day is 5 and Schedule No. 6:
A long beep-pause-a short beep-a short beep-a short beep-pause-a long beep-beep
In the case of remaining days until the reserved day is 0 and Schedule No. 1:
A short beep-a short beep-a short beep-pause-beep
0 0
or
9 6 X X Y Y Y Y
N-8000CO's
outside line number
(Dial
confirmation tone)
Outside line
control password
(Confirmation tone)
Step 3. Either replace the handset or press the [0][0][#] keys.
Note
The contents set through operation from the outside line telephone are saved to the N-8000AF unit once a day
(at 00:00 AM).
If the N-8000AF is turned off before the contents are saved, the time signal schedule returns to the setting
contents that were programmed before power-off.