Toa N-8000 Series - Manual (Page 321)

3-17
Chapter 3 INSTALLATION & WIRING
Step 2. Mount the N-8000AF/8000CO/8000AL on the wall.
Notes
• Use appropriate screws for the construction of wall.
• Wood screws 3.5 x 20 are supplied with the YC-850.
• The socket-outlet shall be installed near the equipment and the plug (disconnecting device) shall be
easily accessible.
Cord clamp
Power supply cord
Protect against disconnection
(Power supply plug)
Unlock cord clamp and run the
power supply cord through it.
Note
Keep the cable length between a
power supply plug and cord clamp
as short as possible.
Wood screw 3.5 x 20
(supplied with the YC-850)
Wall surface
Note: This figure represents the N-8000CO/8000AL.
6. INSTALLATION Of The IP MODULe
Install the SX-200IP IP Module in the module slot of the SX-2000AI or SX-2100AI Audio Input Unit.
For details, refer to the installation manual attached to the SX-200IP.