Toa N-8000 Series User Manual
Page 484
Chapter 5
SYSTEM SETTINGS BY SOFTWARE
IP Station: Remote Mic Settings
5-74
[Setting the details of the function]
(1) Paging (N-8000)/Zone (SX)
Broadcast destinations can be selected either from zones of the SX-2000 system or those of the N-8000 system.
Multiple zones can be set.
If the SX-2000 system zone is set, a control output pattern can also be programmed. (
Step 1. Select "N-8000" or "SX-2000."
Step 2. Click the [Zone] or [Zone pattern] button to determine the broadcast destination.
Zone button:
Sets one zone.
Clicking on this button displays the Zone dialog,
then enter the number.
Zone pattern button: Sets the paging zone pattern.
Clicking on this button displays the Pattern
selection dialog, then enter the number.
Step 3. Repeat the operation in Step 2 as needed to add the broadcast destination.
Clicking the [Zone] button followed by the [Zone pattern] button allows the zones or channels to be
added.
But it is not possible to mix and set the N-8000 zones and SX-2000 zones.
Step 4. (Only when "SX-2000" is selected in Step 1) To activate the control output pattern in synchronization
with broadcast, program the control output pattern by clicking the [COUT pattern] button.
Select the ID of the SX-2000 system, then enter the pattern number.
The ID of the SX-2000 system is the system ID having been
assigned to the SX-200IP IP module in the Gateway settings (
).
Multiple control output patterns can be programmed by repeating
operations.