VACUUBRAND MV 10C VARIO - Manual (Page 12)

page 12 of 51
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. manual-no.: 999073 / 15/12/2009
The controller can be adapted to the specific application by choosing another basic
setup than ”Vacuum control” (factory-set), see section ”General view basic set-
ups”.
The status of the controller respectively of the connected accessories is displayed by
corresponding symbols on the LCD. After switching on the version of the software is
displayed. Then the basic setup is displayed as well as the symbols ”coolant valve”
and ”venting valve”, if the valves are preselected.
Description
General view display
automatic mode
Pressure reading
selectable
pressure units
process control
active
warning (in combination with
other symbols)
setups coolant valve pump symbol time
counter
venting valve
remote operation
setup vacuum control or
continuous pumping
setup VACUU•LAN