Viconics VT7200 Installation Manual (Current Release 5000 Series PIR Ready) - Manual (Page 15)

15 | PIR Ready VT7200 Series-Installation Guide
Zoning Models
When heating & reheat is ON, the HEAT LED will illuminate
When cooling is ON, the COOL LED will illuminate
U
SER
I
NTERFACE
Unoccupied mode override
An Override can be made during an unoccupied period. If the Override option is enabled
in the lockout configuration pressing the Override button will resume occupied setpoints
for a time specified by parameter ToccTime
Local keypad interface
 Any setpoint change can be permanent or temporary based on configuration
parameter (Setpoint Type)
 Any setpoint written through the network, will be permanent and cancel any
active temporary setpoints
 Lockouts of access to certain functions is made with configuration parameter
(lockout)
 An Override can be made during an unoccupied period. If the Override
option is enabled in the lockout configuration pressing the override key
will resume occupied setpoints for a time specified by parameter
ToccTime
 In cooling mode only the cooling setpoint is displayed,
 In heating mode only the heating setpoint is displayed
 In auto mode, (See below)
 In cooling mode only the cooling setpoint is displayed,
 In heating mode only the heating setpoint is displayed
 In auto mode, (See below)