Viconics VT7200 Installation Manual (Current Release 5000 Series PIR Ready) - Manual (Page 27)

27 | PIR Ready VT7200 Series-Installation Guide
RA/DA
Reverse acting or Direct
acting signal for Analog
output signals
VT72xxF5x00(x) models
only
Default value: DA signal
Changes the action of the analog outputs on the analog
models.
DA = Direct acting
0 to 100 % = 0 to 10 VDC
RA = Reverse acting
0 to 10 % - 10 to 0 VDC
Reheat
Sets the time base for the
reheat output if used
Default value: 0 = 15
minute Sets the reheat output time base
Valid only if reheat sequences are enabled
0 = 15 minutes
1 = 10 seconds for Solid state relays
UI3 dis
Display supply or
changeover temperature Used as diagnostic / service help to troubleshoot and diagnose
sensor operation
Only when UI 3 is configured as an analog input ( SS or COS )