Compaq SW3324 - Manual (Page 33)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-6 Installation
Writer: Fran Spragens Project: Installation Comments:
File Name:3324_2.doc Last Saved On:3/16/99 11:34 AM
2. Connect the interface cable directly to the console port on the switch and
tighten the captive retaining screws.
3. Connect the other end of the interface cable to a terminal (in some
instances, an adapter may be required to make this connection). You
can also use a straight-through cable with a null modem adapter to make
the connection to the workstation.
4. From your terminal, start the terminal emulation program.
5. Configure the terminal to the following communication settings:
q 9600 baud
q No parity
q 8 data bits
q 1 stop bit
q No hardware flow control
q ASCII character set
Replacing an Installed Gigabit
Ethernet Module into the Switch
The pre-installed modular Gigabit Interface Converter (GBIC) lets you add
multimode and single mode fiber connections to the SW3324 switch. The GBIC
module is installed in the modular slot on the left side of the switch.
To install the GBIC module in the switch, perform these steps:
1. If necessary, remove the existing GBIC connector by gently squeezing
the sides to release it, and pull the GBIC out of the slot.
2. Holding the new or replacement GBIC by its sides, gently squeeze the
plastic pieces located on the front sides of the connector.
3. Insert the GBIC module into the modular slot with the orientation
arrows facing upward.
4. Slide the GBIC back into the slot until you hear it click.
NOTE: GBIC modules are hot plug compliant.