Compaq SW3324 - Manual (Page 46)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-8 User Interface
Writer: Fran Spragens Project: User Interface Comments:
File Name:3324_3.doc Last Saved On:3/16/99 3:05 PM
Table 3-4 describes the SNMP Configuration Menu.
Table 3-4
SNMP Configuration Menu Descriptions
Selection Description
SNMP Private
Community Name
The community name for read/write SNMP access to the device (1-10 character
range; the default name is: “private”).
SNMP Public
Community Name
The community name for read only SNMP access to the device (1-10 character
range; the default name is: “public”).
Trap Destination #1 The IP address of trap destination #1 where SNMP trap messages are forwarded.
Trap Destination #2 The IP address of trap destination #2 where SNMP trap messages are forwarded.
Trap Destination #3 The IP address of trap destination #3 where SNMP trap messages are forwarded.
Trap Destination #4 The IP address of trap destination #4 where SNMP trap messages are forwarded.
Switch Configuration Menu
The Switch Configuration Menu allows you to modify switching-related
configuration parameters. Select b from the Main Menu to view the Switch
Configuration Menu. Figure 3-6 shows the Switch Configuration Menu.
Figure 3-6 SNMP Configuration Menu
SWITCH CONFIGURATION Access Control: READ/WRITE
a. Forwarding Table Configuration Menu
b. Spanning Tree Configuration Menu
c. VLAN Configuration Menu
d. Forwarding Table Aging Time(seconds)
300
e. Broadcast Cutoff Rate 500000
f. Port Mirroring Enable No
g. Mirrored Port 2
h. Mirroring Port 1
i. Transmit Data Mirroring Enable Yes
j. Receive Data Mirror Enable No
k. Class of Service Configuration Menu
x. Previous Menu
Enter Selection: