Turn on typewriter, Insert paper – Sears 16 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2.
Turn On Typewriter
Raise the Paper Support and turn on the Power Switch
located on the right side of the typewriter. The following
initial operations occur
1, A beep sounds and the Power-on Lamp (green) on the
keyboard lights up.
2, The Carrier moves to the extreme left side and then
moves to the left margin: The Printwheel rotates and
stops at the programmed position.
While the above operations are occurring, all other type
writer functions stop. Start the next operation only after
the initial operations are completed.
® Make sure the Printwheel, Ribbon Cassette and Correc
tion Tape are properly installed and that there is a suffi
cient quantity of ribbon and correction tape remaining.
3.
Insert Paper
1)
Insert paper between the Paper Support and Platen Roll
er.
2)
Turn thek Platen Knob on the left of the typewriter to
advance the paper. When the top of the paper comes into
sight, pull the Paper Bail upward by hand, to open it and
continue turning the Platen Knob to feed paper in be
tween the Paper Bail and Platen Roller.
3)
The paper is released when the Paper Release Knob is
turned backward, enabling you to freely move the paper
by hand for alignment purposes.
® Close the Paper Bail and return the Paper Release Knob
to its forward position before typing.