Generac Power Systems 53187 User Manual
Page 83
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 2.5
ENGINE REASSEMBLY
1
PART 2
ENGINE MECHANICAL
Injection Pump Asembly
Install the injection pum p, using the sam e shim s
that w ere rem oved during disassem bly. Connect con
trol rack of pum p w ith LINK and retain w ith SNAP PIN.
Retain pum p w ith bolts and nuts.
NO TE:
The
pum p
shim s
establish
the
Injection
pum p tim ing. W hen reinstalling the sam e Injection
pum p that w as rem oved, use the sam e shim s that
w ere rem oved. Fuel Injection tim ing m ust be ad
justed w henever (a) a new Injection pum p Is In
stalled, (b) a new cam shaft Is Installed, or (c) a n e w
cylinder block Is used. See Part 4, "ENGINE FUEL
SYSTEM " for tim ing adjustm ent procedure.
Oil Filter, Oil Pipe, Feed Pump and Tap
pets
1. Coat oil filter m ounting face w ith light film of oil and
install. Tighten by hand.
2. Install the feed pum p assem bly, using tw o bolts.
3. Coat tappets w ith oil and install.
Cylinder Head Assembly
1. Set each piston at top dead center (TDC), one at a
tim e. W hen the pistons are at top dead center (TDC),
m easure their protrusion above the cylinder block w ith
a depth gauge or a dial indicator. Measure the protrus-
tion of all three pistons. Use the largest protrusion to
select a cylinder head gasket having the correct thick
ness.
PR^R%I?(J
n
TH?ClfNKS
0.018-0.021 inch
(0.45-0.55mm)
0.043 inch
(1.1 mm)
0.022-0.026 inch
(0.55-0.65mm)
158-70939
0.047 inch
(1.2 mm)
0.026-0.029 inch
(0.65-0.75mm)
159-70939
0.051 inch
(1.3 mm)
NO TE: The thickness of the head gasket, w hen
tightened. Is stam ped at top of gasket (as. 1, .2, .3).
Figure 15. Piston Protrusion above Cylinder Block
2. Install the glow plugs.
3. Tighten the cylinder head bolts in three (3) phases
and in the sequence show n in Figure 16. Alignm ent
pins are provided for proper positioning. Coat all bolt
threads w ith m olybdenum disulphide grease.
OIL PIPE EYEBOLT TORQUE
CYL. HEAD FINAL TIGHTENING TORQUE
7-9 Ft.-Lbs. (1.0-1.3m -kg)
33-36 Ft.-Lbs. (4.5-5.0 m -kg)
Figure 16. Cylinder Head Tightening Sequence
PAGE 2.5-4