Cabletron Systems SmartSwitch Router 9032578-02 - Manual (Page 126)

Chapter 7: Routing Policy Configuration Guide
126 SmartSwitch Router User Reference Manual
Creating an Aggregate Destination
To create an aggregate destination, enter the following command in Configure mode:
Creating an Aggregate Source
To create an aggregate source, enter the following command in Configure mode:
Examples of Import Policies
Example 1: Importing from RIP
The importation of RIP routes may be controlled by any of protocol, source interface, or
source gateway. If more than one is specified, they are processed from most general
(protocol) to most specific (gateway).
RIP does not support the use of preference to choose between routes of the same protocol.
That is left to the protocol metrics.
For all examples in this section, refer to the configuration shown in Figure 11 on page 127.
Create an aggregate
destination. ip-router policy create aggr-gen-dest <name>
network <ipAddr-mask>
Create an aggregate source. ip-router policy create aggr-gen-source <name>
protocol <protocol-name>