Configure per-interface control of igmp membership, Configure dvmrp, Starting and stopping dvmrp – Cabletron Systems SmartSwitch Router 9032578-02 User Manual
Page 146
Chapter 8: Multicast Routing Configuration Guide
146
SmartSwitch Router User Reference Manual
To configure the host response wait time, enter the following command in Configure
mode:
Configure Per-Interface Control of IGMP Membership
You can configure the SSR to control IGMP membership on a per-interface basis. An
interface can be configured to be allowed or not allowed membership to a particular
group.
To configure the per-interface membership control, enter the following commands in
Configure mode:
Configure DVMRP
You configure DVMRP routing on the SSR by performing the following DVMRP-
configuration tasks.
•
Creating IP interfaces.
•
Setting global parameters that will be used for all the interfaces on which DVMRP is
enabled.
•
Configuring DVMRP on individual interfaces. You do so by enabling and disabling
DVMRP on interfaces and then setting DVMRP parameters on the interfaces on which
DVMRP is disabled.
•
Defining DVMRP tunnels, which IP uses to send multicast traffic between two end
points.
Starting and Stopping DVMRP
DVMRP is disabled by default on the SSR.
Configure the IGMP host response
wait time.
igmp set responsetime
<num>
Allow a host group membership to
a specific group.
igmp set interface
<ip-addr>
allowed-groups
<ip-addr/subnet mask>
Disallow a host group member-
ship to a specific group.
igmp set interface
<ip-addr>
not-allowed-
groups
<ip-addr/subnet mask>