Cabletron Systems SmartSwitch Router 9032578-02 - Manual (Page 50)

Chapter 3: IP Routing Configuration Guide
50 SmartSwitch Router User Reference Manual
• NetBIOS Datagram Server (port 138)
• TACACS Server (port 49)
• Time Service (port 37)
To configure a destination to which UDP packets will be forwarded, enter the following
command in Configure mode:
Configure Direct Broadcast
You can configure the SSR to forward all directed broadcast traffic from the local subnet to
a specified IP address or all associated IP addresses. This is a more efficient method than
defining only one local interface and remote IP address destination at a time with the ip-
helper
command when you are forwarding traffic from more than one interface in the
local subnet to a remote destination IP address.
To forward all directed broadcast traffic to a specified IP address, enter the following
command in Configure mode:
Monitor IP Parameters
The SSR provides display of IP statistics and configurations contained in the routing table.
Information displayed provides routing and performance information.
To display IP information, enter the following command in Enable mode:
Specify local subnet interface,
destination “helper” IP
address, and UDP port
number to forward ip helper-address interface <interface-name>
<helper-address> <udp-port#>
Forward directed broadcast traffic ip enable directed-broadcast interface
<interface name> |all
Show ARP table entries. arp show all
Show IP interface configuration interface show ip
Show all TCP/UDP connections
and services. ip show connections [no-lookup]
Show configuration of IP interfaces. ip show interfaces [ <interface-name> ]
Show IP routing table information. ip show routes