Setting an ipx qos policy, Specifying precedence for an ipx qos policy, Configuring ssr queueing policy – Cabletron Systems SmartSwitch Router 9032578-02 User Manual
Page 183
SmartSwitch Router User Reference Manual
183
Chapter 11: QoS Configuration Guide
Setting an IPX QoS Policy
To set a QoS policy on an IPX traffic flow, enter the following command in Configure
mode:
Specifying Precedence for an IPX QoS Policy
To specify the precedence for an IPX QoS policy, enter the following command in
Configure mode:
Configuring SSR Queueing Policy
The SSR queuing policy is set on a system-wide basis. The SSR default queuing policy is
strict priority. To change the queuing policy to weighted-fair queuing on the SSR, enter the
following command in Configure mode:
If you want to revert the SSR queuing policy from weighted-fair to strict priority (default),
enter the following command in Configure mode:
Allocating Bandwidth for a Weighted-Fair Queuing Policy
If you enable the weighted-fair queuing policy on the SSR, you can allocate bandwidth for
the queues on the SSR. To allocate bandwidth for each SSR queue, enter the following
command in Configure mode:
Set an IPX QoS policy.
qos set ipx
<name>
<priority>
<srcnet>
|any
<srcmask>
|any
<srcport>
|any
<dstnet>
|any
<dstmask>
|any
<dstport>
|any
<interface-list>
|any
Specify precedence for an
IPX QoS policy.
qos precedence ipx [srcnet
<num>
]
[srcnode
<num>
] [srcport
<num>
]
[dstnet
<num>
] [dstnode
<num>
]
[dstport
<num>
] [intf
<num>
]
Set queuing policy to
weighted-fair
qos set queuing-policy weighted-fair
Revert the SSR queuing
policy to strict priority.
negate
<line within active-configuration containing qos
set queuing-policy weighted-fair>
Allocate bandwidth for a
weighted-fair queuing policy.
qos set weighted-fair control
<percentage>
high
<percentage>
medium
<percentage>
low
<percentage>