Cabletron Systems SmartSwitch Router 9032578-02 - Manual (Page 55)

SmartSwitch Router User Reference Manual 55
Chapter 4: RIP Configuration Guide
To change RIP parameters, enter the following commands in Configure mode.
Configure RIP Route Preference
You can set the preference of routes learned from RIP.
To configure RIP route preference, enter the following command in Configure mode.
Authentication None
Update interval 30 seconds
Set RIP Version on an interface
to RIP V1. rip set interface <interfacename-or-IPaddr> |all
version 1
Set RIP Version on an interface
to RIP V2. rip set interface <interfacename-or-IPaddr> |all
version 2
Specify that RIP V2 packets
should be multicast on this
interface. rip set interface <interfacename-or-IPaddr> |all
type multicast
Specify that RIP V2 packets that
are RIP V1-compatible should
be broadcast on this interface. rip set interface <interfacename-or-IPaddr> |all
type broadcast
Change the metric on incoming
RIP routes. rip set interface <interfacename-or-IPaddr> |all
metric-in <num>
Change the metric on outgoing
RIP routes. rip set interface <interfacename-or-IPaddr> |all
metric-out <num>
Set the authentication method
to simple text up to 8
characters. rip set interface <interfacename-or-IPaddr> |all
authentication-method simple
Set the authentication method
to MD5. rip set interface <interfacename-or-IPaddr> |all
authentication-method md5
Specify the metric to be used
when advertising routes that
were learned from other
protocols. rip set default-metric <num>
RIP Parameter Default Value
Set the preference of routes learned from RIP. rip set preference <num>