Cabletron Systems SmartSwitch Router 9032578-02 - Manual (Page 140)

Chapter 7: Routing Policy Configuration Guide
140 SmartSwitch Router User Reference Manual
4. Create a Direct export source since we would like to export interface/direct routes.
5. Create the Export-Policy for redistributing all interface routes and static routes into
OSPF.
Exporting All RIP, Interface & Static Routes to OSPF
Note: Also export interface, static, RIP, OSPF, and OSPF-ASE routes into RIP.
In the configuration shown in Figure 12 on page 131, suppose if we decide to run RIP
Version 2 on network 120.190.0.0/16, connecting routers R1 and R2.
We would like to redistribute these RIP routes as OSPF type-2 routes, and associate the tag
100 with them. Router R1 would also like to redistribute its static routes as type 2 OSPF
routes. The interface routes would redistributed as type 1 OSPF routes.
Router R1 would like to redistribute its OSPF, OSPF-ASE, RIP, Static and Interface/Direct
routes into RIP.
1. Enable RIP on interface 120.190.1.1/16.
2. Create a OSPF export destination for type-1 routes.
3. Create a OSPF export destination for type-2 routes.
4. Create a OSPF export destination for type-2 routes with a tag of 100.
ip-router policy create direct-export-source directExpSrc
ip-router policy export destination ospfExpDstType1 source
directExpSrc network all
ip-router policy export destination ospfExpDstType2 source
statExpSrc network all
rip add interface 120.190.1.1
rip set interface 120.190.1.1 version 2 type multicast
ip-router policy create ospf-export-destination ospfExpDstType1
type 1 metric 1
ip-router policy create ospf-export-destination ospfExpDstType2
type 2 metric 4
ip-router policy create ospf-export-destination ospfExpDstType2t100
type 2 tag 100 metric 4