Sekonic L-358 - Manual (Page 12)

-8-
4. Basic Operation
2. Setting DIP Switches
1.
Switches for setting modes that are used infrequently are housed in the Battery compartment of
the meter. Select the mode you want prior to beginning measurements.
2. The DIP switches can be set by sliding the DIP switch !8 for the mode you want to select in the
ON position.
EV settings
When DIP switch 1 is turned on, EV exposure reading is possible (ambient light)
Multi settings
When DIP switch 2 is turned on, multiple flash (cumulative) mode is possible.
Direct settings
If DIP switch 3 is on, it is possible to display the shutter speed and Aperture in the stop that are
set by DIP switch 4.
If turned off, shutter speed is displayed in full stop and the Aperture is displayed in 1/10 stop.
Stop settings
The combination of shutter speed and Aperture is displayed in 1/2
stop when DIP switch 4 is off and in 1/3 stop when it is on.
1 2 3 4
T : full stop
F : 1/10 stop T : 1/3 stop
F : 1/3 stop T : 1/2 stop
F : 1/2 stop