Sekonic L-358 - Manual (Page 17)

-13-
1-3 EV mode
Open the Battery compartment cover !6 and slide the EV DIP switch (see page 8) to the ON
position.
1. Hold down the Mode set button !0 and turn the
Jog wheel t to select EV value mode.
2. Press the Measuring button ! 5 to make a
measurement. Release the Measuring button to
complete the measurement. The measured value
(EV value) at that time will be displayed.
At the same time, the shutter speed will be
displayed in the digital display area, and the
corresponding f stop will be displayed in the analog
display area.
While pressing the measuring button, the meter
measures continuously until it is released.
Reference:
“E.u” (Exposure under) or “E.o” (Exposure over) appears when the combination of shutter
speed and aperture are outside the display range. Changing the shutter speed or aperture
with the Jog wheel will allow you to find a combination that is possible.
If the “E.u” or “E.o” readout blinks, this indicates that the light level is beyond the measurement
range of the light meter.
f stop
Shutter speed
EV value
5. Measurement
MODE