CNET CNWR-811P - Manual (Page 11)

CNWR-811P User Guide
8
3. Connect LAN Cable
Connect a standard LAN cable from a 10BaseT or 100BaseTX Hub on your LAN to the
“HUB” port on the CNWR-811P.
4. Connect WAN Cable
Connect the ADSL or Cable modem to the WAN port on the CNWR-811P. Use the cable
supplied with your modem. If no cable was supplied, use a standard LAN cable.
5. Connect Printer Cable
Use a standard parallel printer cable to connect your printer to the Printer port on the
CNWR-811P.
6. Power Up
Connect the supplied power adapter and power up.
Use only the power adapter provided.
7. Check the LEDs
• The Status LED should flash, then turn Off. If it stays on, there is a hardware error.
• The Power LED should be ON.
• One (1) of the LAN LEDs (10 or 100) should be ON.
• The Wireless LED should be ON.
• If the printer is On and On-line, the Print Act LED should be ON.
For more information, refer to LEDs in Chapter 1.