CNET CNWR-811P - Manual (Page 24)

Configuration
21
WAN Status – PPPoE
Figure 12: WAN Status – PPPoE
Status Data
WAN Status
Physical Address The "Hardware" address of this device, as seen by other devices on the
WAN.
IP Address The IP Address of this device, as seen by devices on the WAN.
(This device has 2 IP Addresses; one for the local LAN, and another
for the WAN port.)
Network Mask The Network Mask (Subnet Mask) for the IP Address above.
PPPoE Link
Status This indicates whether or not the connection is currently established.
If the connection does not exist, the Connect button can be used to
establish a connection.
If the connection currently exists, the Disconnect button can be used to
break the connection.
Connection Log
Log Data The Connection Log shows status messages relating to the existing
connection.
The most common messages are listed in the following table.
Buttons
Connect If not connected, establish a connection to your ISP
Disconnect If connected to your ISP, hang up the connection.
Clear Log Delete all data currently in the Log. This will make it easier to read new
messages.