CNET CNWR-811P User Manual
Page 8
Introduction
5
Rear Panel
Figure 3: Rear Panel
Printer Port
Standard parallel printer port. If you wish to share a printer, connect it
here.
WAN port
(10BaseT)
Connect the ADSL or Cable Modem here. If your modem came with
a cable, use the supplied cable. Otherwise, use a standard LAN cable.
DIP switches
Refer to the following table..
PC port
(10/100BaseTX)
If connecting directly to your PC (no Hub) use this port and a stan-
dard LAN cable (RJ45 connectors).
HUB port
(10/100BaseTX)
Use a standard LAN cable (RJ45 connectors) to connect this port to a
10BaseT or 100BaseTX hub.
Use EITHER the PC port OR the Hub port. You can NOT
use both.
Reset Button
When pressed and released, the Wireless A/P Router will reboot
(restart).
This button can also be used to clear ALL data and restore ALL
settings to the factory default values.
To restore the factory default values:
1. Power Off
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the RED
LED has flashed TWICE.
4. Release the Reset Button. The Wireless A/P Router is now using
the factory default values.
PCMCIA slot
Insert the supplied Wireless PCMCIA card into this slot.
• Ensure the power is OFF before inserting or removing the
PCMCIA Card.
• Do not use any other PCMCIA Card.
Power port (12V)
Connect the supplied power adapter here.