CNET CNWR-811P - Manual (Page 9)

CNWR-811P User Guide
6
DIP Switches
DIP Switch Setting Description
1=off
2=off Normal Operation
1=off
2=on DHCP Server function disabled.
1=on
2=off Used to restore Default IP Address
and clear Password (See below)
1=on
2=on Normal Operation.
Restore Default IP Address
and Clear Password
If the CNWR-811P's IP Address or password is lost, the following procedure can be used to
recover from this situation.
1. Turn the power to the CNWR-811P OFF.
2. Set DIP switch 1 ON.
3. Turn the power to the CNWR-811P ON.
4. Operate DIP switch 1 in the following sequence (you have 15 seconds to complete the
sequence):
• OFF
• ON
• OFF
5. The CNWR-811P will now reset, and the Red Status LED flash. The following changes
will have been made. (Other configuration data is unchanged.)
• IP Address set to its default value of 192.168.0.1
• Network Mask set to 255.255.255.0
• DHCP Server is enabled, and will allocate IP Addresses in the range 192.168.0.2 to
192.168.0.51.
• The password cleared (no password).
6. You can now connect to the CNWR-811P and make any configuration changes required.