Cabletron Systems SPECTRUM FRX6000 - Manual (Page 227)

Index-1
Index
A
Accept Reverse Charge 5-20, 6-7
Address 7-8, 7-11, 7-16
Address Table 4-6, 4-8
Admin Status 2-13
Algorithm 4-6
algorithm (subscriber table) 4-4, 4-5
alternate subscriber addresses 4-6
ansiT1 617 D 5-7
Answer Non ConÞgured 8-6
ANXD 5-21
Applying Port-level Changes 2-34, 5-8, 5-20,
6-8, 7-7, 7-15, 8-6
Auto Call 8-8
Auto Call Enabled 7-9
Auto Dial 12-11
Auto Dial Number 12-12
Auto Poll 12-12
Auto Poll Timer 12-12
B
backup DLCI 5-11
Backup Group Number 5-11
Backup Groups 5-12
Backup Protocol 5-11
Backup Use Only 5-7
BAG (Bandwidth Allocation Group) 9-5, 10-4
Bandwidth Allocation 5-7
Bandwidth Allocation Group 5-17, 7-13, 11-6
BECN (backward explicit congestion
notiÞcation) 5-23
BECN Recovery Count 5-10
binary synchronous communications
(BSC) 8-1
Blocked Flag 5-19, 6-6, 8-5, 10-5, 11-7, 11-9,
12-14
Blocked Port Flag 5-6
Break Ratio 12-11
Bridge Enabled 11-3
Bridging Parameters 11-1
bridging support 11-1
Broadcast Address 9-6, 9-10
BSCI 8-1
BSCI Subscriber Information 8-7
C
Call Info in Request Packet 8-4
call requests 4-1, 4-5
Call Timer 12-9
Call User Groups
Make Calls Outside CUG 5-19, 6-5
Rcv Calls Outside CUG 5-18, 6-5
Changes, applying 2-34
Charts and Meters 1-4
Circuit Index 10-13
Clear VC on Last Dev Down 8-6
Closed User Group 5-18, 6-4
Closed User Group Index 5-18, 6-5
Committed Burst Size (BC) 5-10
Committed Information Rate (CIR) 5-9
community name 2-1, 2-2
ConÞguring IP Interface Secondary
Addresse 9-9
ConÞguring IP Interfaces 9-2
ConÞguring IPX Interfaces 10-2
ConÞguring SNA Ports 7-2
Connection ID 8-8, 8-10
Connection Priority 4-5
Connection Without Poll 8-6
Connector Type 2-15, 6-5
Contact Status 2-7
Control Unit ID 8-10
Country Code 12-2
D
Data Mode 7-17
DCE 5-4, 5-5, 5-6, 7-5, 8-5
Default Packet Size 5-17, 6-4
Default Throughput Class 5-18, 6-4
Desired Operational State 7-17
Desired State at Startup 7-17
Destination Address 9-6
Destination Subscriber 9-6, 10-5