CycleOps PowerTap - Manual (Page 21)

Average Heart Rate ( AV)
This value is a running average of the heart rate in BPM. If there is no heart rate
information this will display as 0.
1) Press [MODE] to scroll the cursor to the bottom line of the main display.
2) Press [SELECT] to toggle through the multi-function displays until the “ AV” is
displayed. (FIGURE 23)
INTERVAL MODE
The computer has two display modes. The trip mode shows total trip met-
rics, and the interval mode displays interval specific information. The inter-
val mode functions as a lap marker and is essentially always on.
To begin the first interval, or advance to the next interval:
Press and release [MODE] and [SELECT] simultaneously. NOTE: Do not hold
both buttons down as you will clear all data from the computer.
In trip mode “INT” and the new interval number will appear and disappear
(FIGURE 24) . The computer can mark an unlimited number of intervals
although after nine (9) the marker will begin to count back at one (1). For
example, interval ten (10) is displayed following interval (9) as one (1).
To view interval specific data (power, speed, and multi-function display) from any location on the
display:
1) Hold [MODE] until “INT” appears on the left hand side of the display. The “INT” and interval
number will remain illumined as a forth line in the main display (FIGURE 24). The data displayed
is that of the current interval number shown.
2)To exit back out of interval mode hold [MODE] until “INT” disappears.
21
365
25
152
WATTS
3
MI
AV
watts
speed int
multi
FIGURE 23
FIGURE 24