CycleOps PowerTap - Manual (Page 23)

Computer Setup
The setup feature has four (4) main modes. You do not have to complete all four to change set-
tings. Please reference each mode to determine the correct location to begin. NOTE: The com-
puter illustrations for each mode display the factory default settings.
COMPUTER SETUP MAIN MENU
1) Press either [MODE] or [SELECT] to activate the computer.
NOTE: The version of firmware is displayed upon startup. The most
updated firmware version is available at www.cycleops.com. (FIGURE
26)
2) Extended hold of [MODE] and [SELECT] simultaneously enters com-
puter setup function indicates by a flashing “E”. NOTE: Continue to hold
through “clear all” screen. Releasing hold early will clear all current data.
3) The setup mode displays three (3) letters and numbers 1-4. Each letter represents a setup
menu. A flashing alphanumeric character indicated current selection. (FIGURE 27)
E = exit, return to ride mode
d = restore default settings
T = test mode
1 2 3 4 = setup menus
4) Press [SELECT] to scroll to the desired setup mode.
5) Press [MODE] to begin setup.
23
Set
E
1 2 3 4
t
d
FIGURE 27
Set
1 2 3 4
FIGURE 26