CycleOps PowerTap - Manual (Page 35)

TEST MODE
1) From the computer setup main menu press [SELECT] and scroll until the letter “t” is flashing.
Press [MODE] to enter setup mode.
2) Press [MODE] to scroll through the different test modes as shown by the number. NOTE: Press
and hold [MODE] and [SELECT] simultaneously returns to standard operation.
0 - Model and version.
Displays the model on the middle line and version number on the bottom line.
1 - LCD Test
Press [SELECT] all the LCD segments are displayed. Press [SELECT] to return to the normal screen.
2 - Receiver Test Signal
NOTE: The transmission icon is illuminated.
The middle line display flashes “88” with each blip of data from the receiver whether valid or not.
3 - Heart Rate Signal Test
NOTE: The heart rate signal is illuminated.
The middle line display flashes “88” with each heart rate blip received.
4 - Bike Computer Wheel Magnet Detect
NOTE: The “mi” or “KM” icons are illumined.
The middle line display flashes “88” with each sensing of the wheel magnet next to the receiver.
5 - Cadence Test
NOTE: The C icon is displayed
The top line display shows crank cadence sensor RPM. The middle line flashes “88” with each
pulse from cadence sensor. The bottom display shows cadence RPM value from the hub.
35