CycleOps PowerTap User Manual
Page 38
· Interference with other devices - make sure you are not setting up the PowerTap inside a
building with a lot of electrical noise, neon signs, or near power lines. Bring the PowerTap
outside or away from the electrical disturbance to see if signal returns. Also make sure you don’t
have any other devices on your bike such as lights, magnets or cycle computer sensors.
· Check for damage to receiver & computer mount.
Power seems incorrect
·Torque value is not zeroed to manually read zero torque go to current watts and hold down the
select button until watts disappears. Torque is now being displayed. To zero torque hold down
the select button until the value reads zero. To exit torque mode press select once. If read zero
the torque does not seem to recalibrate the unit call Saris Cycling Group customer service at
1-800-783-7257.
Speed seems incorrect
· Wheel size incorrect -refer to the chart on page 14 and enter the correct size in setup mode.
Transmission icon flashes rapidly
· Hub batteries need replacement - replace the hub batteries as shown on pages 14-15 of
the User Manual.
38