CycleOps PowerTap - Manual (Page 29)

5) Press [SELECT] then [MODE] to reset default settings. Press [MODE] to
save changes.
COMPUTER SETUP 4
This setup menu includes: sleep time, locations of display, cadence source, cycle computer mode,
heart rate monitor, and auto start/stop. You are unable to move back to a previously viewed set-
tings. You must restart setup 4 to make corrections.
1) Press [SELECT] to set how many minutes the computer will stay “awake”
after not receiving a valid speed or heart rate signal. Press [MODE] to save.
NOTE: The shorter the sleep time the better the battery life.
2) Press [SELECT] to determine what is displayed in the middle line. (mi =
speed, c = cadence, (
) = heart rate). Press [MODE] to save. The selected
metric will flash during the ride. NOTE: If heart rate or cadence is selected
speed is not displayed. This is useful for intervals when power, heart rate
and cadence are most important.
3) Press [SELECT] to determine cadence information source.
Default = pedal then hub
Pedal = crank only
Hub = hub only
Press [MODE] to save.
29
PRO
4
4
SLEEP
PRO
4
mi
PRO
4
p e d a l
c
Hu
P