Aiwa Z-VR55 - Manual (Page 12)

NOTE
• When loading an 8-cm f3-inch^ disc, make sure to place it onto
the inner circle of the trav precisely. Otherwise, the disc may
be damaged or the disc compartment will not open. If it does
not open, please consult your Aiwa dealer for repair.
• Do not place more than one compact disc on one disc tray.
• Do not tilt the unit with discs loaded. Doing so may cause
malfunctions.
• When transporting the unit, remove the discs from the trays.
• When replacing the discs during play, do not replace discs other
than those facing you.
If you place a disc on the empty right inner tray, and then press
± OPEN/CLOSE, “ERROR” is displayed and the disc
compartment may not close. Remove the disc on that tray.
RANDOM PLAY
All the tracks on the selected disc or all the discs can be played
randomly.
Press RANDOM on the remote control.
“RANDOM” lights up on the display.
To cancel random play, press again.
To play all discs, press ► to start play.
To play a single disc, press one of DISC DIRECT PLAY 1-5 to
start play.
Up to 30 tracks can be programmed from any of the inserted
discs.
Use the remote control.
1 Press PRGM in stop mode.
“PRG” is displayed .
0 5 0 0
2 Press DIRECT, then press one of the numbered
buttons 1 to 5 within 3 seconds to select a disc.
Go to the next step when the tray stops rotating.
3 Press numbered buttons 0-9 and +10 to program
a track.
Example:
To select the 25th track, press +10, +10 and 5.
To select the 10th track, press +10 and 0.
Selected track number Total number of selected tracks
NOTE
During random play, it is not possible to skip to the previously
played track with
REPEAT PLAY
A single disc or all the discs can be played repeatedly.
Press REPEAT on the remote control.
“Ci-” lights up on the display.
To play all discs, press ► to start play.
To play a single disc, press one of DISC DIRECT PLAY 1-5 to
start play.
bl:
■01
IP
Program number Total playing time of the
selected tracks
4 Repeat steps 2 and 3 to program other tracks.
5 Press ► to start play.
To check the program
Each time ◄◄ or ►► is pressed in stop mode, a disc number,
track number, and program number will be displayed.
To clear the program
Press BCLEAR in stop mode.
To add tracks to the program
Repeat steps 2 and 3 in stop mode. The track will be programmed
after the last track.
To change the programmed tracks
Clear the program and repeat all the steps again.
During programmed play, you can not use random play, check
the remaining time or select a disc or track.
11 ENGLISH