Sleep 60, When using the remote control, To display the current time – Aiwa Z-VR55 User Manual

Page 18: To switch to the 24-hour standard, If the clock display flashes, To cancel the sleep timer

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CLOCK AND TIMER

1

Press CLOCK/DIMMER once, then press ENTER

within 4 seconds.

'

I ' . .

..

.. , ,

The unit can be turned off automatically at a specified time.

1

Press SLEEP on the remote controi.

£» '-/.SLEEP 60

When using the remote control

Press CLOCK, then press 11 SET within 4 seconds.

2

Turn MULTi JOG to designate the hour, then press

ENTER.

The hour stops flashing and the minute starts flashing.

3

Turn MULTI JOG to designate the minute, then

press ENTER.

The minute stops flashing on the display and the clock starts
from 00 seconds.

To display the current time

Press CLOCK/DIMMER once. The time is displayed for 4

seconds.

However, the time cannot be displayed during recording.

To switch to the 24-hour standard

Press CLOCK/DIMMER once and then press ■ within 4

seconds.

Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes

This is caused by a power interruption. The current time needs
to be reset.

If power Is Interrupted for more than approximately 24 hours,

all settings stored In memory after purchase need to be reset.

2 Within 4 seconds, turn MULTI JOG or press

or ►► to specify the time untii the power is turned
off.

The time changes between 5 and 240 minutes in 5-minute
steps.

Specified time

i./" -

To check the time remaining until the power is turned off

Press SLEEP once. The remaining time is displayed for 4

seconds.

To cancel the sleep timer

Press SLEEP twice so that “SLEEPoFF” appears on the display.

*

and ►► are also available instead of MULTI JOG.

* USET is also available instead of ENTER.

1 7

ENGLISH

Advertising