Aiwa Z-VR55 - Manual (Page 17)

ADDITIONAL DOLBY PRO LOGIC MODES ^
1 Press the VIDEEO/AUX/PHONO and start playback
of the video source.
2 Press DOLBY PRO LOGIC.
NORMAL is selected, and the playback sound has the DOLBY
PRO LOGIC effect.
To cancel DOLBY PRO LOGIC mode
Press DOLBY PRO LOGIC repeatedly until “P-OFF” is displayed.
To change the sound levels during playback
After adjusting the balance with the noise sequencer, the sound
levels of the center or surround speakers can be adjusted during
playback of laser discs or video software.
1 Press MANUAL SELECT (TEST) on the remote control
repeatedly to select “CEN” (center), “S-R” (surround right) or
“S-L” (surround left).
2 While the “CEN”, “S-R” or “S-L” is displayed, press ◄◄ or
on the remote control to adjust the volume.
In addition to the NORMAL mode, this unit is also equipped with
the PHANTOM and the 3 STEREO modes.
PHANTOM mode: Use this mode when no center speaker is
connected. The center channel signals are output through the
left and right speakers.
3 STEREO mode: Use this mode when no surround speakers
are connected. This mode reproduces rear sounds through the
front speakers.
To select PHANTOM or 3 STEREO
Press DOLBY PRO LOGIC repeatedly until the desired DOLBY
PRO LOGIC mode is displayed. The DOLBY PRO LOGIC mode
is displayed cyclically as follows.
NORMAL—►PHANTOM - ■3 STEREO
]
--------------- P-OFF-----------------
(cancel)
To adjust the balance of connected speaker sound levels
Carry out steps 2 to 4 on page 15.
' Depending on the sound source and/or listening conditions,
surround effect may not be obtained even when the DOLBY
PRO LOGIC is on.
• The full DOLBY PRO LOGIC effect cannot be obtained when
using software without □□| oouvsubrqumd | mark.
«The DOLBY PRO LOGIC is automatically canceled when:
- the DSP SURROUND system is turned on.
- the headphones are plugged in.
- the 5.1 CH (page 20) is turned on.
Ü
0
O
o
cc
a
>■
a
'ji
o
o
ENGLISH 1 6