Echelon i.LON 600 LonWorks/IP Server - Manual (Page 112)

Section 3: Appendixes
Figure 52. Configuration Server Log
10. Verify that the Configuration Server is attached to your IP network by checking the
Enabled in the Network menu. The Configuration Server should detect the IP
address of your PC.
11. Verify your PC’s IP address by selecting Settings from the Network menu and
confirming that the Configuration Server’s proper IP address is listed in the
TCP/IP address or host name field. The Local IP button shows the available
IP addresses for your network channels. On the Configuration Server main
dialog screen in Step 7, the New Channel’s Server Address is set to
10.5.250.17, port 1629. This confirms that the Configuration Server is running
on a PC with an IP address of 10.1.3.78, and the utility is using port 1629 to
create the L
ON W ORKS /IP devices on PCs running LNS 3.01 or later only
respond to Configuration Server setup messages when the L ON W ORKS /IP device
is open. To force a L ON W ORKS /IP device to open, run the L ON W ORKS /IP
Channels control panel and click the Start Test button as shown in Figure 32 .
104 Using Your i.LON 600 as a Remote Network Interface