Echelon i.LON 600 LonWorks/IP Server - Manual (Page 68)

Section 2: Advanced Topics
An urgent trace message was generated. The urgent trace messages include:
Table 11. Urgent Trace Messages
Message Description
WebServer Activated/Deactivated
(remotely) Indicates that the WebServer state was changed remotely using the
Configuration Server.
NVRAM reset to factory defaults The NVRAM contents have been reset to the factory default settings.
Web server is unable to open
WebParams.dat The Web server program could not open the WebParams.dat file. Ensure a
copy of the file is available.
Time Synchronization disabled, no
server Time synchronization was lost because there are no longer any configured time
servers. This will not be logged when the system is first starting.
Time Synchronization failed, server:
<address> Time synchronization was lost because time server at the indicated IP address
failed to respond within two seconds. If there is more than one time server
configured, resynchronization will be automatically attempted with a different
server.
Time Synchronization established,
server: <address> Time synchronization was established with the time server at the indicated IP
address. This will not be logged when the system is first starting.
Router: persistent data lost due to
<reason>
or
Suggested action: recommission the
router or application instance. A configuration image or node definition image was lost. This forced the
application instance or router to an unconfigured state. It must be
commissioned via a LONWORKS network management tool. The reason for
the loss is one of the following:
“an image corruption” – The image file located in /root/ltConfig was corrupted.
“a program ID change" - This might occur when changing the application mix
"a signature mismatch" - The image file was corrupted.
"a reset or power cycle while updating persistent data" - During or shortly after
a L
ON W ORKS network management update, the device was reset.
Persistence Update Failure: File
system write error. The system was unable to write a persistence file for an application or router.
The file system could be out of space or corrupted. Verify the amount of free
space remaining by running the chkdsk command in the Console Application
and then deleting any unused files.
Router Persistence: Unable to write
persistent data block. The system was unable to write a persistence file for an application or router
stack. The file system could be out of space or corrupted. Verify the amount of
free space remaining by running the chkdsk command in the Console
Application and then deleting any unused files.
Router Persistence - discarded due to
local IP address change.
IP address is x.x.x.x was x.x.x.x The IP address of the i.LON 600 server has changed. This is expected after the
IP address has been changed and the server rebooted. The server must be
reconfigured with the Configuration Server. The L
ON W ORKS parameters are
preserved in this case.
Router - Unable to restart link to
Configuration Server. Communication has been lost with the Configuration Server. Ping the
Configuration Server from the i.LON 600 using the ping command from the
Console Application. If the ping succeeds, verify the necessary ports are open.
Startup - Server start failed
An unforeseen error has prevented a proper startup. Consider setting "factory
defaults" through the Console Application or setup web page. This applies only
when using VNI.
L ON W ORKS channel priority lowered to
<n> due to transceiver swap.
Unit running with one transceiver type was rebooted with a new transceiver
type. The priority slot configured for the old type exceeded the maximum for the
new type. Recommend that a new priority slot be assigned, using a
LONWORKS network management tool. This applies only when using VNI.
60 L ON W ORKS /IP Channel Parameters